3 Assembly and installation [specialist]
2019/09 99E13331xx-mub-en - V02 7
3 Assembly and installation [specialist]
3.1 Assembly of the controller
The following section describes only the installation of the controller. Follow the instructions
of each respective manufacturer when installing external components (valves etc.).
1. Temperature sensors
2. Flow sensors
3. Outputs PWM
4. Modbus
5. RS232
6. Outputs 230 V
7. Supply
Risk of death by electrocution!
Disconnect the controller from the power supply before opening the
casing.
Make sure that the power supply cannot be unintentionally switched on
when the casing is open.
To Next Page
Loading...
