PINPAD Instruction Manual
(SP20
，SP30，S200，S300)
1.Instructions
PINPAD connect to POS or ECR by a communication line for entering password during
transaction process. In order to correct using, you should refer to following instructions.
1）Magnetic Stripe Card
Put magnetic stripe side of magnetic card towards device interior, swipe the card with a steady
speed during through magnetic reader slot. (Support bi-directional swiping)
2）IC Card
Put IC card chip side upward, push-in IC card slot and to bottom.
3）Tap contactless card (optional).
Put the contactless card into the sensing area above the LCD
4）SAM Card
① Remove the SAM card cover (At the bottom of the terminal).
② Insert the SAM card to the corresponding card slot.
2. Installation and Usage Tips
1）Avoid putting the terminal in direct sunlight, high temperature, moist, or dusty environment.
2）Forbid non-professional to repair the terminal.
3）Before insert the card, please check internal and around of IC card slot . when you found some
suspicious objects , must report to related administrator.
3. Password Entering Tips:
It is highly recommended to enter password as following ways:
1）Set up peep shields. Enter password with shield by the structures of cashier desk;
2）Place the POS terminal at an appropriate angle and make sure it is difficult to peer the password.
For example, the POS was installed above the movable bracket.
3）In enter password perspective, avoid surrounding video surveillance;
4）Paste text instructions to remind the customers to shelter with body or palm when enter
password.
5）Merchants can also choose other ways to protect the customer input password.
FCC Regulations:
This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This mobile phone has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiated radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
To Next Page
Need help?
General
