Need help?Do you have a question about the PAX PWM100 and is the answer not in the manual?
General| Model | PWM100 |
|---|---|
| Max Flow | 100 m³/h |
| Measurement Principle | Ultrasonic |
| Protection Class | IP68 |
| Type | Water Meter |
| Max Head | Not Applicable |
| Pipe Diameter Range | DN50-DN200 |
| Output Signal | 4-20mA |
| Material | Stainless Steel |
Details warranty terms, disclaiming implied warranties and subject to change without notice.
Highlights risks of electric shock, explosion, or arc flash during installation, adjustment, repair, and maintenance.
Warns against consequences of product use and operating damaged equipment, advising contact with PAX representative.
Explains safety symbols and provides critical warnings for confined spaces, lifting, fall protection, and licensed contractors.
Describes the PWM100 as an active vortex mixer for small tanks, highlighting its mixing capabilities and ease of installation.
Details PAX's commitment to high-quality products, continuous improvement, ethical standards, and NSF/ANSI 61-G certification.
Lists essential tools for installation, including wire stripper/crimper, diagonal cutter, multimeter, and current clamp.
Provides detailed steps for bringing power, installing the disconnect switch, running conduit, and lowering the mixer into the tank.
Explains how to turn the PAX Water Mixer ON by energizing the GFCI breaker and disconnect switch, and how to turn it OFF.
Lists the required equipment for electrical checks: Multimeter and Current Clamp.
Provides a chart for quick reference of electrical measurements including resistance, voltage, and current for the mixer.
Recommends annual electrical checks and periodic operational verification for the PAX Water Mixer.
Lists available replacement parts for the PAX Water Mixer, including service kits with part numbers and quantities.
To Next Page