X
Single or multiple codes
Silent operation
20 wrong keystrokes
= 60 second lockout
Door open time
(seconds)
Change
Programming Code
Exit button
Set a user code
Data Reset (except
Programming code)
One code only
Multiple codes allowed
Silent
Beep on
OFF
ON
Enter time in seconds
(default = 07, max = 60)
Open door for
time in option 5
Toggle door open until
pressed again or toggle
code entered
Enter user code
4-8 digits
Re-enter user
code
Enter 6 digit
Programming
Code
= Delete
= Normal
= Toggle
= Duress
Enter 6 digit
Programming
Code
Re-enter 6 digit
Programming
Code
6
X
2
4
6
8
OR
OR
OR
OR
OR
OR
OR
OR
Lock wire setting
Fail locked
Fail open
2
2
2
2
2
2
1
3
4
7
5
6
9
8
6
6
6
6
9
START - Enter the 6 digit Programming Code and hold down a function key for
3 seconds. - The unit beeps and the LED ashes faster.
Continue the key sequence to set the option - The keypad returns to operating
mode.
= default setting
= Hold down for
3 secs
1. Power down the system.
2. Power the system up whilst holding down button 3.
3. The unit will beep/ash LED’s 3 times a second.
4. Go to - Initialising a new system.
Full System Reset
This box can be used to write down the Programming Code for future reference.
Ensure that this information is stored in a secure place.
To Next Page
Loading...
General