Technical Support
Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)
Saturday from 09:00 - 13:00 (GMT)
support@paxton.co.uk
01273 811011
Fitting
A detachable gure 8 power cable is provided with the unit. This is pre-stripped at one end for
connection to a fused spur.
Anchor points are supplied inside the case to secure the incoming mains cable. (cable tidy/ties are
provided) There are also 'knock-outs' in the case to allow convenient access for the cable.
Ensure that the supplied compression gland is used when passing the mains cable through any holes in
the cabinet.
1. Screws and wall plugs are provided in a tting kit. With reference to the diagrams, determine where
the top, central mounting position is required and drill a hole suitable for a No 8 wall plug.
2. Tap in one of the wall plugs.
3. Put in one of the long screws, leaving a suitable gap to the wall surface and slide the cabinet over it.
4. Mark the hole positions for the lower 2 screws.
5. Remove the cabinet and drill the additional holes.
6. Tap in the 2 wall plugs and hang the cabinet back onto the top screw.
7. Secure the cabinet with the 2 lower screws.
8. Tighten the top screw.
AC Mains Connection
The power supply is double insulated and requires no additional earth connection.
The PSU's battery function will not work until this unit has rst been connected to the mains supply.
It is the loss of this supply that switches the unit to battery power.
Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/
To Next Page
Loading...
Need help?
General
