pcl D10 - Start-up and Operation; Start-up Procedure; Standard Operation: Inflation;Deflation; Tyre Wear Inspection Warning

PCL ACCURA D10 Tyre Inflator
www.pclairtechnology.com
Start-up
1. Turn on power supply
2. Display will show all LCD digits check
3. Display will show the current Firmware version number e.g.
'.3.0.4'
4. Display will show Program model variant '300' ( psi default)
or '302' (bar default)
5. Display will show the application, 'Std'
6. After 10 seconds the display will show 'PCL'
7. The unit will then display the set default pressure
Do not connect the hose to the tyre during start-up or E5
will show
Standard Operation
Inflation and deflation
1. Set desired pressure, by touching either or
2. Connect the hose to the tyre.
3. Automatic inflation will commence to the set pressure,
periodically stopping to display the pressure of the tyre.
4. If the pressure in the tyre is below 3 psi, 0.2 bar or 20 kpa,
the process will not commence until is touched.
5. When the Set pressure is reached, the buzzer will sound
and the display will show 'END' with the final pressure.
6. Remove the hose from tyre.
7. For selection of alternative pressure unit touch
For adjustments to Inflators parameters
please refer to your Distributor or PCL.
Refer to the vehicle manufacturers recommended pressure when
setting the required pressure.
Inspect tyres for any signs of wear or
damage, any suspect tyres should not be
inflated with this unit.
User Inspection mode
It is possible to set the inflator to act as a pressure gauge.
The display resolution is changed and can be used to reference the
inflator against a calibrated pressure source. The inflator automatic
cycle is inhibited.
To access:-
1. Touch and together
2. The unit will beep but the display will not change
3. Touch 5 times
(if this is not undertaken within 10 seconds, the Inflator
reverts back to normal Inflator mode)
4. Display will show the pressures to the minimum resolution:
psi = 0.1 / Bar = 0.01 / kpa = 1 / kg/cm = 0.01
5. Connect the hose to the tyre and the display will show the
pressure in the tyre
6. When complete, touch any button to return to the last set
mode.