OzoneJets: All swim spas are equipped with ozone jets for sanitaon. The filter cycle should cir‐
culate 8‐10 hours daily for proper ozonaon. Use the programmable electronic control center to
program this operaon.
Ozonator: Your EverPure™ ozonator will operate in conjuncon with your filtraon system.
Ozone is a gas, O
3,
that has been used for years as a sanitaon treatment for drinking water, and
now as a proven purifier for swim spas and hot tubs.
SlideValves: Valves are used to shut off the water flow to the heater, circulaon pump,
Secondary pump, and Fitness pumps for specific service problems.
SupportPack: The control system operates all funcons of the swim spa. Make sure your
electrician connects the power supply accordingly to all Naonal Electric Code, and shows you
how to test the GFCI circuit breaker (not supplied). This pack is connected to a 50 amp breaker
and for dual zone products; FX219, FX219s and TSX 219, there will be two packs, one for the fit‐
ness zone and another for the spa zone.
WaterwayNeo2100TruSwimControl:Digital lighted control center operates all pump
funcons, temperature control, scheduled filtraon cycles, lights and workout modes. Refer to
the Control secon of this manual for programming of personalized propulsion speed for custom
workouts.
WaterwayNeo2100Control:Used to control all swim spa funcons. The topside is used to
control the water temperature, pumps, spa light, programmable filtraon cycles, and funcons.
The topside will display between the water temperature and the me, as well as display error
codes relang to service needs.
CirculaonPump:A dual speed pump designed to use low speed for water filtraon and heang
and a high speed for hydrotherapy. The jets one buon on the topside control will acvate the
circulaon pump. The FX219, FX219s and TSX219 will have a second circulaon pump for the spa
zone.
Heater:Your swim spa is equipped with a thermostat control at the spa side (topside control).
Set the swim spa at the temperature you enjoy. Leave the thermostat at that seng, and the
swim spa will automacally maintain the correct temperature; ready for your enjoyment anyme.
Avoid constant reseng of the thermostat; it is more economical to maintain temperature then
to let the temperature fall and raise. Never raise the temperature above 104 degrees. Never
raise temperature above 86 degrees for swimming or exercising.
Parts Descripon and Funcon
9
To Next Page
Loading...
Need help?
General
