PDC spas SYNERGY Series FX15 User Manual

A good general rule is to visually inspect your swim spa and equipment area frequently. If anything looks
broken, worn, or incorrect, contact your electrician or spa retailer. A simple repair may prevent an injury or more
serious problems requiring expensive repairs. If your swim spa is not operang, check the following:
1.Nothingontheswimspaoperates
Check power source G.F.C.I. breaker. (or equivalent)
Check to assure spa has dedicated circuit.
Check the “test” and “reset” buons on G.F.C.I. (or equivalent)
Check internal fuses.
Review control panel for any error code. Refer to that secon of this manual.
2.Pumpdoesnotwork
Check all items above.
Check filter; clean or replace cartridge.
Check for blockages (restricons) at sucons, skimmer and pump.
Push “pump” buon(s) to check if high speed is funconing, on a dual‐speed pump.
3.Inadequatejetacon
Make sure jets are turned on.
Make sure air controls are open.
Check for restricons (blockages) in jets and/or main skimmer and pump.
Check water level.
Push “pump” buon(s) to check if high speed is funconing on a dual‐speed pump.
Check to be sure the diverter valve is in center posion.
Check for dirty filters and change if necessary.
4.Noheat
Check all steps under part “1”.
Check temperature sengs.
Check for clogged filter element and other restricons.
Check water level.
Check if pump is running.
5.Nolight
Check “light” buon.
Check G.F.C.I. (or equivalent) “test” and “reset” buons.
6.Wateriscloudy
Increase circulaon cycle.
Test water chemistry.
Clean/replace filter cartridge.
7.GFCIorequivalentistripping
A ground fault circuit interrupter (GFCI) is required by the Naonal Electric Code for your protecon.
The tripping of the GFCI may be caused by a component on the spa or by an electrical problem.
Electrical problems include although are not limited to, a faulty GFCI breaker, spa component, power
fluctuaons, or improper wiring. If this new electrical service and GFCI installaon, an instantly
tripping GFCI may likely be caused by improper wiring of the neutral from the GFCI to the spa. Contact
a qualified technician to recfy the problem. 
Ifabovechecksdonotsolvetheproblem,contactaqualifiedservicetechnician.
Basic Troubleshoong
53

PDC spas SYNERGY Series FX15 Specifications

General

Brand	PDC spas
Model	SYNERGY Series FX15
Category	Hot Tub
Language	English