PDP 051-038-NA User Manual

(PS4) used to operate the PS4™ system
(TV) used to operate the TV
(AMP) used to operate the AV amplifier
(CBL) used to operate a cable/satellite set-top box
Operating a TV, A/V amplifier, or cable/satellite set-top box
You can use the Universal Media Remote to operate a TV, A/V amplifier, or set-top box.
Set the remote code to match the product in use.
NOTE: Some functions of your original remote may not be controlled by this remote.
Use the original remote, if available, to control such functions. Sometimes buttons other
than described in these instructions may actually perform the function. For example, the
channel and volume buttons might be used to navigate through menu choices. We
recommend you experiment with the remote to identify if such situations apply to your
equipment.
Programming TV, AMP, and CBL devices
There are two ways to program TV, AMP, and CBL devices, AUTO SEARCH MODE, or
MANUAL ENTRY MODE.
Auto Search Mode
1. Turn the target device ON.
2. Point the Universal Media Remote directly at the target device and make sure it
stays pointed at the device throughout the programming process.
3. On your Universal Media Remote, press and hold down the green PWR key and
the desired device key for about 5 seconds. The red LED on the remote will turn
on, indicating that it is now in Auto Search Mode.
4. Keep the remote pointed at the device.
5. When the remote locates the correct code, the device will turn OFF.
6. When the device turns OFF, immediately press any key to complete
programming.
7. If the red LED turns off and programming was not successful, please use manual
entry mode.
Manual Entry Mode
1. Turn the target device ON
2. Refer to the Manufacturer’s Code List included in the product documentation.
3. Find the brand name of the target device.

PDP 051-038-NA Specifications

General

Brand	PDP
Model	051-038-NA
Category	Remote Control
Language	English