Peak Performance PKC0RE

Questions and Answers

M
matthewwagnerJul 27, 2025
What to do if my Peak Performance Automobile Parts receiver always indicates an object?
- P
  paulandreaJul 27, 2025
  If your Peak Performance Automobile Parts receiver always indicates an object is behind the vehicle, even when there isn't one, it could be due to a couple of reasons. First, the sensors might be mounted incorrectly or have shifted from their original position; in this case, check their location and alignment, realigning them as needed. Second, the sensors could be covered with obstructions like snow, mud, or ice. Make sure the sensors are clean.
R
ronaldpowellAug 1, 2025
Why Peak Performance PKC0RE receiver and/or controller power LEDs don't illuminate in reverse?
- M
  Molly RomanAug 1, 2025
  If your Peak Performance Automobile Parts receiver and/or controller power LEDs do not illuminate when the vehicle is put into reverse, it is likely due to loose or improperly connected sensor system wires. Ensure all wires are correctly connected to the receiver, controller, sensors, and into the vehicle reverse light circuit. Check all wire connections and splices for proper connection.
T
Tiffany AdamsAug 8, 2025
What to do if Peak Performance Automobile Parts receiver has false or no response?
- A
  Alexander ReyesAug 8, 2025
  A false or no response from your Peak Performance Automobile Parts receiver could stem from several factors. The sensors might not operate properly if the vehicle is on a steep hill, if there are thin objects behind the vehicle, if bushes or leaves are absorbing signals, or if high-power electrical wires nearby are interfering with the signal. Also, the sensors may be covered with snow, mud, or ice, so cleaning them is important. Ensure the sensors are correctly mounted and aligned. Check that all wires are correctly connected and that the receiver power switch is on. Always be aware of the surrounding areas while operating the vehicle.
M
mark43Aug 13, 2025
What to do if Peak Performance PKC0RE receiver power LED illuminates but doesn't detect obstacles?
- V
  Vanessa OlsonAug 13, 2025
  If your Peak Performance Automobile Parts receiver power LED illuminates but doesn't detect obstacles, it's possible that the sensor system wires are loose or improperly connected. Ensure the sensor system wires and connectors are properly inserted into the controller’s 2-pin receptacle.
V
vaguirreAug 19, 2025
How to fix Peak Performance PKC0RE Automobile Parts receiver that doesn't indicate correct distances?
- W
  wagnermichaelAug 20, 2025
  If your Peak Performance Automobile Parts receiver isn't indicating the correct distances, the sensors might be mounted incorrectly or have moved. Check the sensor location and alignment. Realign them as necessary.