Peak Performance PKC0RE - System Operation; Care and Maintenance; Storage; Cleaning

OFF
ON
Using a small piece of wire or paper clip
, push the learn link button on the back of the receiver.30.
Wh
en a mutual frequency has been found, the receiver will beep twice. If a mutual frequency was 31.
no
t found, the red LEDs next to the “0.4m/1.3ft” on the receiver will ash, but the receiver will not
beep. If this happens, switch the receiver o and back on and push the learn link button again to
repeat the procedure. If a problem still persists, check the system installation.
OPERATION
While driving in re
verse, a beep will sound and a green LED will light up when an object is 5 feet 1.
(1
.5 m) away. If the object is more than 5 feet (1.5 m) away, there will be no sound and the LED will
not light up.
As you get closer to an object, the beeping speed will increase and additional LED lights will light 2.
up.
When all
LEDs are lit and the alarm is a constant sound, stop the vehicle
immediately. Continuing in reverse may damage vehicle or back-up sensors.
When you are 16 in. (0.4 m) or closer, both green, both yellow and the red LEDs will light and the 3.
beep will be a constant sound.
The volume can be adjusted using the v
olume control dial on the receiver.4.
Distance Alarm LED Lights
ov
er 5 ft (1.5 m)
No beep No LEDs illuminate
59-47 in. (1.5-1.2 m)
(•) beep Green LED illuminates
47-39 in. (1.2-1.0 m)
(•) (•) beep Green LED illuminates
39-24 in. (1.0-0.6 m)
(•) (•) (•) beep Yello
w LED illuminates
24-16 in. (0.6-0.4 m)
(•) (•) (•) (•) beep Y
ello
w LED illuminates
under 16 in. (0.4 m)
Constant sound All LEDs illuminate
C
ARE AND MAINTENANCE
Storage
St
ore this Back-Up Sensor in a cool, dry area and keep it away from direct sunlight, heat, excessive
humidity and dampness.
Cleaning
Do not clean or wipe the Back-Up Sensor with solvents or chemical materials
. If necessary, remove
dirt or stains using a soft cloth dampened with a mild detergent solution.
Disposal
The B
ack-Up Sensor is designed to provide years of service. The Back-Up Sensor should
be recycled or safely disposed of at a local recycling center. Examples of places that will
accept items like this are: county or municipal recycling drop-o centers or scrap metal
dealers.