What to do if Peak Atlas ESR display shows 'Auto discharge taking too long!'?
If your Peak Measuring Instruments display shows 'Auto discharge taking too long!', it's advised to manually discharge the capacitor safely before attempting the analysis again.
What to do if Peak Measuring Instruments display shows 'Warning! V=132V Safely discharge'?
If the Peak Measuring Instruments display shows 'Warning! V=132V Safely discharge', you should safely discharge the capacitor manually.
What to do if Peak Measuring Instruments display shows 'In)Circuit/Leaky' even though it’s a new capacitor and out'of' circuit on Peak?
If your Peak Measuring Instruments display shows 'In)Circuit/Leaky' even with a new capacitor out of circuit, try measuring it again a few times. This 'exercising' of the capacitor may resolve the issue.
Why does my Peak Atlas ESR Measuring Instruments display show 'Removing trace charge'?
The message 'Removing trace charge' on your Peak Measuring Instruments indicates the device has detected potential 'Soakage' or 'Dielectric Absorption' in the attached capacitor, which is normal. The instrument is ensuring the capacitor is fully discharged to prevent voltage build-up after the discharge process.
Lists key features like ESR measurement range, resolution, capacitance range, and automatic functions.
Explains the capacitor discharge circuitry and user responsibility for safely discharging capacitors.
Details crucial safety precautions for operating the ESR meter and handling components.
Explains Equivalent Series Resistance (ESR) and its impact on capacitor performance.
Discusses manufacturer ESR specifications and frequency considerations for accurate readings.
Covers initial setup, pre-analysis checks, and safety before connecting probes.
Details the analysis steps, how ESR and capacitance are displayed, and interpreting results.
Explains ESR measurement ranges, resolution, and considerations for parallel capacitors.
Explains how ESR readings are affected when measuring capacitors connected in parallel.
A table showing typical ESR values for various capacitor types and voltage ratings.
Provides context for typical ESR values, factors affecting them, and how to interpret the data.
Summarizes the audible tones produced by the ESR70 and how to control them.
Details the step-by-step procedure for performing probe compensation to ensure accurate readings.
Explains potential error messages during probe compensation and their causes.
Covers general care, avoiding damage, and the importance of timely battery replacement.
Addresses incorrect ESR readings with shorted probes and probe compensation errors.
Explains display messages for soakage, absorption, slow discharge, and leaky capacitors.
Covers hardware failure indications and advice for new capacitors showing 'In-Circuit/Leaky'.
Details the product warranty, coverage, and conditions for repair or replacement.
Provides information on WEEE regulations and the proper disposal of electronic waste.
General| Brand | Peak |
|---|---|
| Model | Atlas ESR Series |
| Category | Measuring Instruments |
| Language | English |
To Next Page
