Momentary Preset Programming
The PGR4N has a momentary mode to toggle the LOOP status in the current preset when PGR4N receives
the same MIDI Program Change message (PC). This means you can toggle L1 – L4 that you have saved in
the preset.
1. Apply POWER (1) to the PGR4N.
2. Send the preset/patch from your MIDI foot controller to turn the PGR4N to the required preset.
3. When the PGR4N receives the MIDI Program Change message (PC) then the L1-L4 will show the
current settings of LOOP1 – LOOP4 (see table-10).
4. Press & hold S1 (2) switch for 3 seconds to enter to the momentary mode setting (see table-11).
P4 P3 P2 P1 Mode description
Momentary Preset Programming
Table-11 Momentary Preset Programming.
5. P1 & P2 Led’s will be flashing to show you the current momentary mode status of the selected preset.
6. Press S1 (2) or S2 (2) switch to enable/disable the momentary mode (see table-12) and press &
hold S1 (2) for 3 seconds. This will either enable/disable the momentary mode of the selected preset.
P4 P3 P2 P1 Mode description
Enable Momentary Preset (Momentary preset mode)
Disable Momentary Preset (Latch mode)
Table-12 Momentary Preset Programming.
7. If you enable the momentary mode then L1-L4 will show the status of the current momentary preset
(see table-13).
8. Press S1 (2) switch (INC LOOP +1) or press S2 (2) switch (DEC LOOP -1) then L1 – L4 will show the
LOOP on/off status.
9. When you have completed setting the LOOPs then press S1 (2) for 3 seconds to save the loop setting
into this preset memory.
10. To cancel please press the S2 (2) switch for 3 seconds (or simply remove the POWER plug).
To Next Page
Loading...
Need help?
General