Peak PKC0RA - User Manual

Model No.: PKC0RA
Wireless Back-Up Camera and Monitor
Dear Customer,
CONGRATULATIONS. The PKC0RA Wireless Back-up Camera and Monitor, when used as
described, it will improve your ability to see behind your car, truck, RV, or mini-van. We have
taken numerous measures in quality control to ensure that your product arrives in top
condition, and will perform to your satisfaction.
Before You Install
Automotive video equipment installations can be difficult at times, even to the most
experienced of installation technicians. If you are not confident working with 12 volt DC
vehicle wiring, removing and reinstalling interior panels, carpeting, dashboards or other
components of your vehicle, contact the vehicle’s manufacturer, or consider having the
PKC0RA professionally installed.
This device, as well as all other wireless devices, may be subject to
interference. Interference may be caused by cell phones, Bluetooth
headsets, Wi-FI routers, power lines and other various electrical equipment,
etc.
Parts
1. Monitor and mounting Arm 2. Camera
3. Transmitter Box 4. Camera Mounting Accessories
4. Monitor Power Cable 5. Transmitter Box Power Cable
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Installation
These instructions do not apply to all vehicles. They are only meant as a general guide
due to the number of different makes & models.
For vehicle specific questions contact your vehicle’s manufacturer.
MONITOR INSTALLATION
When choosing a location to mount the monitor, make sure the monitor is in an area that will
not obstruct your vision while driving.
Choose a Location and Install Power Cable
1. Temporarily place the monitor in the location that you have chosen
2. Route the power cable to the vehicle’s cigarette lighter socket/12V
power outlet. The cable must not interfere with the safe operation of
the vehicle.
Mounting the Monitor
Before mounting the monitor, clean the mounting surface well.
1. Position the suction cap mount to the smooth surface which suits
your requirement.
2. Press the suction cap against the smooth surface such as
windshield or dashboard.
3. Press the lock down to attach and fix the mount to the surface.
4. Snap in the monitor to the suction cap mount.
5. Adjust the mounting arms to suit your view angle to the monitor.

Summary

Wireless Back-Up Camera and Monitor

Before You Install

Interference Concerns

Potential interference from other wireless devices and electrical equipment.

Installation Guide

Monitor Installation

Instructions for mounting the monitor unit in the vehicle.

Monitor Power Connection

Details on connecting the monitor to the vehicle's 12V power source.

Monitor Controls Overview

Explanation of the monitor's buttons, indicators, and adjustment options.

Camera Installation Procedures

Procedures for mounting and wiring the camera unit.

System Testing

Steps to verify the camera and monitor are functioning correctly.

Compliance and Notices

FCC & Industry Canada Information

Regulatory compliance and warnings for radio frequency devices.

California and Minnesota Driver Notice

State-specific warnings regarding suction mount usage.

Limited Warranty and Service

Obtaining Service

Instructions for returning the product for warranty claims.

Peak PKC0RA Specifications

General

Brand	Peak
Model	PKC0RA
Category	Automobile Electronics
Language	English