PeakTech 1220 - Page 120

7.15. Setting of Time Base Mode
The time base mode menu is explained as the following table.
Function menu
Setting
Explanation
TimeBase
Main
Horizontal main time base is used to wave display.
Set Window
Zone
Use two cursors to define a window area.
Zone Window
Expand the defined window to full-screen display.
For the operation of window extension, please execute the following steps:
1.) Press MENU key, display the function menu on the right side of the screen.
2.) Press MENU▲ or MENU▼ key to select TIME MODE, display three options at the bottom.
3.) Press F2 key to select Zone Window.
4.) Press OPTION key to pop up TIME BASE, at this time, then press ◄OPTION and ►OPTION key to adjust the
time base window area defined by two cursors, the window size will vary.
5.) Press OPTION key and call TIME, at this time, press ◄OPTION and ►OPTION to adjust the window position
defined by two cursors, the window position is the time difference of the window center to main time base’s
horizontal pointer.
6.) Press F3 key, select Window, the defined window extends into the full-screen display.
The screen that looks like the following figure 60, 61 will be displayed.
Figure 60: Window Setting
Figure 61: Window Extension
-119-