7.16 Data Transmission
For the operation of data transmission, please execute the following steps:
1.) Press MENU key, display the function menu on the right side of the screen.
2.) Press MENU▲ or MENU▼ key to select DISP SET mode, display four options at the bottom.
3.) Press F4 key, and select the Bitmap or Vectors for data transmission.
4.) Use a data line to connect the oscilloscope and the PC.
5.) Open the DS_WAVE software that had been installed completely.
6.) Setting the parameter under the user’s manual, and then starts data transmission.
-120-
To Next Page
Loading...
