5.7 Input Connections
See figure 2 on page 69.
Look at the bottom and the right of the Oscilloscope. The Oscilloscope has six signal inputs: one safety BNC jack input for
scope measurements, four safety 4-mm banana jack inputs for Multimeter R, V and A measurements.
Isolated input allows independent floating measurements between Multimeter and Scope.
5.8 Displaying an Unknown Signal with Auto Set
The Auto-Set feature lets the Oscilloscope display and measure unknown signals automatically. This function optimizes
the position, range, time base, triggering and assures a stable display of virtually any waveform. This feature is especially
useful for quickly checking several signals.
To enable the Auto-Set feature, do the following:
1.) Connect the test probe to the tested signals.
2.) Press the AUTO SET key and the Oscilloscope is under the automatic measurement condition. The tested signals
appear on the screen.
5.9. Automatic Zero of Trigger Horizontal Position and 50% setting of Trigger Level Position
When we adjust the trigger horizontal position and trigger level position to be maximal to make it off the screen center
remotely, then we perform the following steps to make trigger horizontal position and trigger level position return to zero
automatically.
1.) Press “V” key, the trigger horizontal position automatically returns to zero.
2.) Press “R” key, the trigger level position automatically sets to 50%.
-76-
To Next Page
Loading...
