5.10. Automatic Measurements
The Oscilloscope offers 18 types of automatic scope measurements. Your can display two numeric readings:
measurement 1 and measurement 2. These readings are selectable independently, and the measurements can be done
on the input waveform.
To choose a frequency measurement, do the following:
1.) Press MENU key and the function menu appears on the right side of the screen.
2.) Press MENU ▲ or MENU ▼ key to select MEAS SET1. Four items selectable are visible at the bottom of the
screen.
3.) Press F5 to view the next five entries. A total of 18 automatic measurement functions are available for selection.
4.) Press F1 key to select “Freq” measurement. The MEAS SET 1 window shows the frequency for input waveform.
To choose a Peak-Peak measurement for measurement 2, do the following:
1.) Press MENU key and the function menu are displayed on the right side of the screen.
2.) Press the MENU ▲ or MENU ▼ key and select MEAS SET 2. Again, a total of 18 measurement functions are
available for selection.
3.) With the F5 key to scroll to the next page.
4.) Press F4 key to select PK-PK. The MEAS SET 2 window shows the peak-peak value for input waveform.
See the following figure 9:
Figure 9: Automatic Scope Measurements
-77-
To Next Page
Loading...
