5.11. Freezing the Screen
You can freeze the screen (all readings and waveforms)
1.) Press the RUN/STOP key to freeze the screen and STOP appears at top right side of the screen.
2.) Press the RUN/STOP key once more to resume your measurement.
See the following figure 10:
Figure 10: Freezing the Screen
5.12. Using Average for Smoothing Waveforms
Using the Average acquisition mode, you can smooth out the displayed waveform by averaging
multiple data samples. The number of averaging is selectable from 4, 16, 64, and 128.
Note:
In order for average mode to work in the best way, the waveform must be repetitive; As the number of averaging increases,
the slower the waveform update becomes.
1.) Press the MENU key and the function menu appears on the right side of the screen.
2.) Press MENU ▲ or MENU ▼ key to select ACQU MODE, with four items selectable displayed at the bottom of the
screen.
3.) Press the F3 key to select “Average”, then, press F4 key to jump to “Averages 16” item. This averages the
outcomes of 16 acquisitions and shows the final averaging result on the screen, shown as the following figure.
See the following figure 11:
Figure 11: Average Factor Sampling Mode
-78-
To Next Page
Loading...
