6.3. Making Multimeter Measurements
Press DMM/OSC key, the oscilloscope will switch to the multimeter measure, the screen will display the multimeter
windows.
6.3.1 Measuring Resistance
Caution!!
Discharge capacitors before measuring! Do not make any measurements on voltage sources.
To measure a resistance, do the following:
1.) Press the R key and R appear at the top of the screen.
2.) Insert the black lead into the COM banana jack input and the red lead into the V/Ω banana jack input.
3.) Connect the red and black test leads to the resistor. The resistor value readings are shown on the screen in Ohm.
Now, you can see a screen that looks like the following figure 17.
Figure 17: Resistance Measurement
-83-
To Next Page
Loading...
