To measure a DC current which is larger than 400 mA, do the following:
1.) Press the A key and DCA appears at the top of the screen. The unit on the main reading screen is mA.
2.) Press F5 key change to 10A measurement, the unit on the main reading screen is A.
3.) Insert the black lead into the COM banana jack input and the red lead into the 10A banana jack input.
4.) Connect the red and black leads to the measured point and the DC current value of the measured point will be
displayed on the screen.
5.) Press F4 return to 400 mA measure.
Look at the display, you can see a screen that looks like the following figure 24.
Figure 24: DC Current Measurement for 10A
-88-
To Next Page
Loading...
