6.4. Freezing the Readings
You can freeze the displayed readings at any time.
1.) Press the RUN /STOP key to freeze the screen and STOP will be displayed at the top right of the screen.
2.) Again, press the RUN /STOP key, you can resume your measurement.
Look at the display you can see a screen that looks like the following figure 27.
Figure 27: Freezing the Readings
6.5. Taking a Relative Measurement
A currently measured result relative to the defined reference value is displayed in a relative measurement.
The following example shows how to take a relative measurement. At first, it is required to acquire a reference value.
1.) Press R key and R is displayed on the top side of the screen.
2.) Press the SET key till C appears at the top of the screen.
3.) Plug capacitance extended module in capacitance measure jack.
4.) When the reading leveling off, press F2 key and △ is displayed on the top side of the screen. The saved reference
value is displayed below △.
5.) Plug capacitance, the displayed major reading on the screen is actual the capacitance value.
Look at the display, you can see a screen that looks like the following figure 29.
Figure 28: Relative Measurement
-91-
To Next Page
Loading...
