7. Advanced Function of Oscilloscope
This chapter will detail the oscilloscope function of the test tool.
7.1. Setting of the Channel
1.) Press the MENU key and the function menu appears at the right of the screen.
2.) Press the MENU ▲ or MENU ▼ key to jump to CH SETUP and 4 options appears at the bottom of the screen.
3.) Select and press key from F1 through F4 keys to make different settings.
Now, you can find a screen that looks like the following figure 30.
Figure 30: Setting of the channel
The following Table describes the Vertical Channel menu:
The DC component in the input signal is blocked.
The AC and DC components of the input signal are allowed.
Input signal is interrupted.
To Next Page
Loading...
