7.1.1. Setting the Channel Coupling
Example:
1.) Press F1 key set Coupling as AC to make an AC coupling setting. The DC component contained in the tested
signal is blocked.
2.) Press F1 key set Coupling as DC to make a DC coupling setting. Both DC and AC components contained in the
tested signal are permitted.
3.) Press F1 key set Coupling as Ground to make a Ground coupling setting. Input signal is interrupted.
The waveform is displayed as the following figure 31, figure 32, and figure 33.
Figure 31: AC Coupling
Figure 32: DC Coupling
Figure 33: Ground Coupling
-94-
To Next Page
Loading...
