When the sync Line NUM, the second page menu is shown as below.
Set the line values to increase
Set the line value to decrease
Set and show the line value
Back up to previous menu.
When you go to the holdoff menu, you can see a screen in the following Figure39.
Figure39: Trigger Holdoff
The Holdoff menu is described in the following table:
Set time slot before another trigger event.
Set the off time to increase.
Set the off time to decrease.
Reset Holdoff time to100ns.
Back up to previous menu.
Note:
Trigger Holdoff can stabilize complex waveform, such as the pulse range. Holdoff time is the oscilloscope’s waiting period
before starting a new trigger. During Holdoff, oscilloscope will not trigger until Holdoff ends.
-98-
To Next Page
Loading...
