PeakTech 2015 A User Manual

33
1. Safety Precautions
This product complies with the requirements of the following
directives of the European Union for CE conformity:
2014/30/EU (electromagnetic compatibility), 2014/35/EU
(low voltage), 2011/65/EU (RoHS). Pollution degree 2.
CAT I: For signal level, telecommunication, electronic with
small transient over voltage
CAT II: For local level, appliances, main wall outlets,
portable equipment
CAT III: Distribution level, fixed installation, with smaller
transient overvoltages than CAT IV.
CAT IV: Units and installations, which are supplied
overhead lines, which are stand in a risk of
persuade of a lightning, i.e. main-switches on
current input, overvoltage-diverter, current use
counter.
To ensure safe operation of the equipment and eliminate the
danger of serious injury due to short-circuits (arcing), the
following safety precautions must be observed.
Damages resulting from failure to observe these safety
precautions are exempt from any legal claims whatever.

PeakTech 2015 A Specifications

General

Type	Digital Multimeter
DC Voltage Ranges	200mV, 2V, 20V, 200V, 600V
DC Current Ranges	200µA, 2mA, 20mA, 200mA, 10A
AC Current Range	200mA, 10A
Resistance Ranges	200Ω, 2kΩ, 20kΩ, 200kΩ, 2MΩ, 20MΩ
Capacitance Range	20nF, 200nF, 2µF, 20µF, 200µF
Frequency Range	20 kHz
Diode Test	Yes
Continuity Test	Yes
Battery Test	1.5V, 9V
Overvoltage Category	CAT II 600V
Power Supply	9V battery
Measurement Functions	Voltage, Current, Resistance, Capacitance, Frequency, Diode, Continuity, Battery
DC Voltage Accuracy	±(0.5% + 2 digits)
AC Voltage Ranges	200V
DC Current Accuracy	±(1.0% + 2 digits)
Resistance Accuracy	±(0.8% + 2 digits)
Safety Standard	IEC 61010-1
Display	3 1/2 digit LCD