Need help?Do you have a question about the PeakTech 1035 and is the answer not in the manual?
General| Product type | Digital multimeter |
|---|---|
| DC voltage range | 600 V |
| Resistance range | 0.1 - 2000 Ω |
| Battery test mode | Yes |
| Measuring category | CAT III 600V |
| Placement supported | Handheld multimeter |
| Battery test mode range | 1.5 - 9 V |
| Resolution (AC voltage) | 100 mV |
| Resolution (DC current) | 2000 µA |
| Resolution (DC voltage) | 200 mV |
| Basic accuracy (DC current) | +/- 0.5% |
| Battery type | 9V |
| Power source | Battery |
Provides a brief overview of the multimeter's capabilities and design.
Lists the key functionalities and technical highlights of the multimeter.
Instructions on how to clean the multimeter's exterior safely and effectively.
Details the specifications for measuring DC voltage.
Details the specifications for measuring AC voltage.
Details the specifications for measuring DC current.
Details the specifications for measuring resistance.
Details the specifications for performing diode tests.
Identifies and describes the various controls and indicators on the multimeter's front panel.
Provides important initial considerations before operating the multimeter.
Step-by-step guide for measuring DC voltage using the multimeter.
Step-by-step guide for measuring AC voltage using the multimeter.
Step-by-step guide for measuring DC current using the multimeter.
Step-by-step guide for measuring resistance using the multimeter.
Step-by-step guide for testing diodes using the multimeter.
Instructions on how to use the multimeter to test batteries.
Procedure for replacing the multimeter's 9V battery.
Legal information regarding battery disposal and regulations.
Instructions on how to replace the multimeter's fuses.
To Next Page
