14
Cleaning and Care
• Always unplug the power supply from the power
outlet before cleaning.
• Caution! Water must not enter the device.
• Clean the housing with a slightly damp cloth.
Clean the display with special screen cleaning
cloths. Always check the instructions of the
cleaning agent. Certain agents might not be
suitable for cleaning this product.
• Do not use any sharp, abrasive or aggressive
cleaning agents.
• Do not use any chemicals (e.g. gas, alcohol) to
clean the housing.
Disposal
Do not dispose of this appliance as unsorted
municipal waste. Return it to a designated
collection point for the recycling of WEEE.
By doing so, you will help to conserve resources
and protect the environment. Contact your retailer
or local authorities for more information.
Select input
1. With the monitor turned on, push the
multifunction switch to the right.
2. Select the desired input, HDMI or VGA by
pressing the multifunction switch up/down.
3. Confirm the selection by pressing the
multifunction switch to the left.
FreeSync
The “freesync” function can reduce blurring,
ghosting and juddering, and can also reduce lag
with videos, games and any other fast-moving
content.
To activate the “Freesync” function, the computer
display card required to fulfill one of the below
minimum requirements:
1. AMD APU and independent video card can
support this function;
2. NVIDIA video card can only be supported by
DP 1.2 port using NVIDIA GeForce 10 Series
or above.
Set picture characteristic
1. With the monitor turned on, press the multi-
selector switch up until the desired characteristic
has been set. You can choose from:
FPS Gaming
Low blue light mode
Movie mode
Reading mode
RTS Gaming mode
Standard mode
2. Confirm the selection by pressing the
multifunction switch to the left or wait a few
seconds until the symbol disappears.
IM_PMO-S241_S271-IFC_201127_V03_HR.indb 14IM_PMO-S241_S271-IFC_201127_V03_HR.indb 14 27/11/2020 11:21 AM27/11/2020 11:21 AM
To Next Page
Loading...
Need help?
General
