Hum and Noise:
Output Residual Noise S/N Ratio Test Conditions
Ref. 0 dBu
Master L/R -100 dBu 104 dB All faders down
-88 dBu 92 dB Master fader nominal,
Channel faders down,
All channels muted
-84 dBu 88 dB All controls nominal,
mic gain min.
Mono -90 dBu 94 dB All faders down
-88 dBu 92 dB Master fader nominal,
Channel faders down,
All channels muted
Monitors -102 dBu 106 dB All faders down
-90 dBu 94 dB Master fader nominal,
All channels muted
Effects -95 dBu 99 dB All controls off
Sends
-82 dBu 86 dB All channel sends nominal
(Hum and Noise Measurements: 22 Hz to 22 kHz BW)
Equivalent Input Noise (EIN):
-129 dBu (Input terminated with 150 ohms)
Crosstalk:
>80 dB adjacent input channels (20 Hz — 20 kHz)
>70 dB left to right outputs (20 Hz — 20 kHz)
Common Mode Rejection Ration (Mic Input):
50 dB min. (20 Hz to 20 kHz)
70 dB type @ 1 kHz
Meters:
12 segment, peak reading
(0 dB = +4 dBu)
Signal/Overload Indicators:
Red LED lights 2 dB below clipping
Dimensions (H x W x D):
AAM 802: 5.500" x 15.000" x 16.500" (13.97 cm x
38.10 cm x 41.91 cm)
AAM 1602: 5.500" x 23.000" x 16.500" (13.97 cm
x 58.42 cm x 41.91 cm)
Weight:
AAM 802: 13.7 lbs. (6.21 kg)
AAM 1602: 19.7 lbs. (8.93 kg)
Features and specifications subject to change without notice.
Peavey Electronics Corporation • 711 A Street • Meridian • MS • 39301
(601) 483-5376 • FAX (601) 486-1678 • http://aa.peavey.com
©2001 Printed in the U.S.A. 02/01
To Previous Page
Loading...
