Need help?Do you have a question about the Peavey Mark IV and is the answer not in the manual?
Displays channel operational state, -10 dBV (green) and +10 dBV (red) indicators.
Dual control for input attenuation and gain adjustment, monitored by LEDs.
Two separate controls for monitor mixes, signal taken before equalization.
15 dB boost/cut at 15 kHz, shelving configuration for highs.
15 dB boost/cut at 3 kHz, peak/notch type for upper mids.
15 dB boost/cut at 400 Hz, peak/notch for lower mids.
15 dB boost/cut at 60 Hz, shelving for controlling low frequencies.
Post-fader control for sending signal to external effects or internal reverb.
Assigns channel output balance to sub-masters or sum.
Allows pre-fade listen signal for channels via headphones.
Controls channel output mix level, sends signal to sub-masters or sum.
Controls output level for the submaster 1 mix.
Controls output level for the submaster 2 mix.
Final gain elements determining output level for monitor mixes A and B.
Controls output level for submasters 3 and 4 mixes.
Final gain control for all effects send controls.
Master function setting pre-fade listen level for headphones.
Final gain determining element for the overall mix output.
Guidelines for setting up monitor mixes after input gains are established.
Details on the mixer's 4-band equalization and crossover specifications.
Warranty terms, exclusions, and repair/replacement procedures.
Factors that void the warranty and its limitations.
Warning about potential permanent hearing loss from high noise levels.
Precautions regarding signal clipping, tape use, and general operation.
Displays channel operational state, -10 dBV (green) and +10 dBV (red) indicators.
Dual control for input attenuation and gain adjustment, monitored by LEDs.
Two separate controls for monitor mixes, signal taken before equalization.
15 dB boost/cut at 15 kHz, shelving configuration for highs.
15 dB boost/cut at 3 kHz, peak/notch type for upper mids.
15 dB boost/cut at 400 Hz, peak/notch for lower mids.
15 dB boost/cut at 60 Hz, shelving for controlling low frequencies.
Post-fader control for sending signal to external effects or internal reverb.
Assigns channel output balance to sub-masters or sum.
Allows pre-fade listen signal for channels via headphones.
Controls channel output mix level, sends signal to sub-masters or sum.
Controls output level for the submaster 1 mix.
Controls output level for the submaster 2 mix.
Final gain elements determining output level for monitor mixes A and B.
Controls output level for submasters 3 and 4 mixes.
Final gain control for all effects send controls.
Master function setting pre-fade listen level for headphones.
Final gain determining element for the overall mix output.
Guidelines for setting up monitor mixes after input gains are established.
Details on the mixer's 4-band equalization and crossover specifications.
Warranty terms, exclusions, and repair/replacement procedures.
Factors that void the warranty and its limitations.
Warning about potential permanent hearing loss from high noise levels.
Precautions regarding signal clipping, tape use, and general operation.
General| Brand | Peavey |
|---|---|
| Model | Mark IV |
| Category | Music Mixer |
| Language | English |
To Next Page
