Need help?Do you have a question about the Peavey Bass Mark IV and is the answer not in the manual?
General| Preamp | Solid State |
|---|---|
| Effects Loop | Yes |
| Power Amp | Solid State |
| Speaker Configuration | 1x15" |
| Dimensions | 24" x 24" x 12" |
| Power Output | 300 Watts RMS into 2 Ohms |
| Inputs | 1 x Instrument |
| Type | Bass amplifier |
Details the high and low gain inputs and their functions, including overload prevention.
Explains the function of the Pre Gain control for Channel A and its relation to clipping.
Explains the Post Gain control as the master gain for Channel A, emphasizing dynamic range.
Details the built-in crossover network for bi-amping and its associated patching.
Explains the Pre Gain control for Channel B, referencing Channel A's description.
Details Channel B's active EQ section with four controls for shaping tone.
Details the six-band graphic equalizer and its assignment to channels A and B.
Provides specifications for the 400BH™ power module with DDT™ compression.
Details preamp section specifications, including input levels and equalization.
Provides system hum and noise specifications at nominal input levels.
Lists essential safety and operating instructions to follow before and during use.
Warns about potential hearing loss from high noise levels and recommends protection.
To Next Page