Need help?Do you have a question about the Peavey Mark VI Series Bass and is the answer not in the manual?
General| Power Output | 300 Watts RMS |
|---|---|
| Weight | 28 lbs (12.7 kg) |
| Dimensions | 21.5" (W) x 10.75" (D) x 5.5" (H) (54.6 cm x 27.3 cm x 14 cm) |
| Preamp | Solid State |
| Effects Loop | Yes |
| Inputs | 1 x 1/4" |
| Type | Bass Amplifier |
| Power Output @ 4 Ohms | 300 Watts |
| Input | 1/4" Input Jack |
| Direct Output | XLR Direct Output |
| Outputs | XLR Direct Output |
Input used for most electric basses, 6 dB louder than Low Gain Input.
For instruments with high outputs to prevent overdriving the High Gain input.
Controls the input volume level of the channel.
Controls the overall volume level of the amplifier.
Enables/defeats DDT™ compression to protect speakers.
Turns the amplifier on and off.
Protects the amplifier; must be replaced with the same type and value.
3-wire line cord for safety and grounding.
For connecting external speaker(s); minimum total impedance is 4 ohms.
Details rated power, clipping, frequency response, THD, dynamic range.
Details nominal levels, input/output levels, impedance for preamp.
Read instructions, obey cautions, use near water, proper placement.
Proper power supply connection, cord handling, and grounding importance.
To Next Page
