Need help?Do you have a question about the Peavey M-4000 and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Channels | 2 |
| Signal to Noise Ratio | >100 dB |
| Rackmount Size | 2U |
| Impedance | 2 Ohms |
| Input Impedance | 20k Ohms balanced, 10k Ohms unbalanced |
| Weight (Approximate) | 25 lbs |
Adjusts input gain; calibration indicates voltage needed for full output.
Explains input sensitivity and dBV monitoring for amplifier status.
Internal circuit to prevent clipping distortion.
Illuminates when DDT TM Compression is active.
Power LED indicates AC power; Power Switch turns the unit on/off.
Automatic shutdown and reset system to prevent overheating.
Jacks for connecting external speakers; minimum 4 ohms impedance.
Safety features including a grounded line cord and replaceable fuse.
For selecting correct operating voltage (220/240V for export models).
Inputs, receptacles, and outputs for electronic crossover modules.
Detailed technical data for the M-7000 model.
Detailed technical data for the M-4000 model.
Crucial information on hearing protection and general operational cautions.
To Next Page
