Need help?Do you have a question about the Peavey M-2600 and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Channels | 2 |
| Signal to Noise Ratio | > 100 dB |
| Input Impedance (Balanced) | 20 kOhms |
| Input Impedance (Unbalanced) | 10 kOhms |
| Frequency Response | 20Hz - 20kHz |
| Total Harmonic Distortion | <0.1% |
| Damping Factor | > 300 |
| Dimensions | 3.5" H x 19" W x 15.25" D |
Illuminates when DDT Compression is active; indicates clipping if DDT is defeated.
Indicates power status and provides manual power control for the amplifier.
Adjusts input gain, affecting sensitivity and headroom for optimal output.
Protects speakers from clipping distortion by automatically engaging.
Provides switching functions for stereo and dual-channel mono operation modes.
Connects external speakers, requiring a minimum total impedance of 4 ohms.
Features a 3-wire grounded cable for safety and noise reduction.
Details one-year warranty for most parts and 90-day for tubes/meters.
Instructions for completing and mailing the warranty registration card.
Guidance on fuse replacement and voltage selection for export models.
Details frequency response, power ratings, distortion, and noise levels.
Covers warnings for hearing loss, electrical hazards, and proper usage.
To Next Page
