Need help?Do you have a question about the Peavey MMA81502 and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Channels | 8 |
| Power | 1500W |
| Impedance | 4 ohms |
| Frequency Response | 20 Hz - 20 kHz |
| Signal to Noise Ratio | > 100 dB |
The green LED indicates when AC power is supplied to the unit and the power switch is on.
The green LED indicates signal presence at the amplifier output.
The red LED indicates when SPS circuitry is active. SPS eliminates power amplifier clipping.
Controls the signal level of the input channels 1-8 respectively to the mix bus.
Indicates signal presence (green) and peak (red) conditions of the channel input signal prior to the level controls. Be cautious not to overdrive the mix bus.
Controls the signal level of the program input to the mix bus.
Adjusts low frequencies; clockwise boosts, counter-clockwise cuts (±10 dB).
Adjusts high frequencies; clockwise boosts, counter-clockwise cuts (±10 dB).
Selects EQ status: OUT for active controls, IN for flat EQ.
Red LEDs indicate mute bus status; lights when activated.
Controls the overall level of the system.
For the IEC line cord providing AC power. Never break off the ground pin for safety.
This rocker switch applies mains power to the unit.
Located in fuse holder cap. Must be replaced with the same type and value to avoid damage and warranty voiding.
Provides AC power for auxiliary equipment (max 300 Watts); not controlled by power switch.
Provides direct and transformer isolated outputs for amplifier/loudspeaker interface.
Accepts optional PLUG-IN MODULES not requiring +5V power supply.
Accepts optional PLUG-IN MODULES requiring +5V power supply.
Provides a 6 dB/octave low frequency roll-off at 60 Hz for transformer isolated outputs.
Provides a line level output of the Master Level mix output to drive external devices.
Direct input to power amplifier with 1 Volt sensitivity. Allows insertion of signal processors.
Output signal independent of Master level, EQ, and High EQ controls. Can be used as a mixing output point.
Auxiliary input for signals from other sources, controlled by Program level control.
Terminals connect to Shield for mute bus activation, feeding PLUG-IN MODULES.
Allows use of an external master volume control. Front panel Master Level must be at maximum.
Details the 4 Ohm Direct Output and transformer isolated outputs (8 Ohm, 25V, 70V) for the MMA81502 (120V).
Details the 4 Ohm Direct Output and transformer isolated outputs (8 Ohm, 70V, 100V) for the MMA81502 (230V).
Details the 4 Ohm Direct Output and transformer isolated outputs (8 Ohm/25V, 70V, 100V) for the MMA8752.
Details the 4 Ohm Direct Output and transformer isolated outputs (8 Ohm, 70V, 100V) for the MMA8352.
Covers defects in material and workmanship in Peavey products purchased and serviced in the U.S.A. and Canada.
Excludes damage from accident, misuse, abuse, improper installation, rental, modification, neglect, shipment, unauthorized repair, or defaced serial numbers.
Protects only the original retail purchaser of the product.
The warranty begins on the date of purchase by the original retail purchaser. Duration varies by product category.
Peavey will repair or replace covered products at no charge for labor or materials. Consumer pays initial shipping, Peavey pays return shipping.
Instructions on how to obtain warranty service, including taking the item to a dealer or shipping it to Peavey.
Limits implied warranties like merchantability and fitness for a particular purpose to the duration of this warranty.
Limits Peavey's liability to repair or replacement and excludes incidental or consequential damages.
To Next Page
