Peavey Backstage Chorus 208 - Front Panel Controls; Input and Gain Controls; Channel and Effect Selection; Tone and EQ Adjustments

ENGLISH
4
1 2 3 5 6 7 8 9 10 11 12 13 14 15 16
HIGH GAIN INPUT (1)
Used for most electric guitars. It is 10 dB louder than the Low Gain input.
LOW GAIN INPUT (2)
Provided for instruments that have extremely high outputs, which can result in overdriving (distorting) the
High Gain input. If both inputs are used simultaneously, the output levels are the same (both are High Gain).
NORMAL GAIN (3)
Controls the volume level of the Normal channel and is not affected by the SuperSat® or Post Gain controls.
CHORUS SELECT SWITCH (4)
The “in’* position of this switch activates the Chorus effect. The “out” position defeats the Chorus.
NOTE: The Chorus effect must be activated to be controlled via remote footswitch.
CHANNEL SELECT SWITCH (5)
Allows selection of the Lead or Normal channel. The “in” position of the switch selects the Lead channel
and the “out” position selects Normal.
NOTE: Channel selection may also be accomplished by the remote footswitch. If the remote selection is desired
the channel switch must be in the “in” (Lead) position.
LOW, MID, & HIGH EQ (6)
Passive tone controls that regulate the low, mid and high frequencies, respectively.
S UPERSAT®/PULL GAIN (7)
A transistor simulation of tube distortion (soft clipping). To activate the SuperSat effect. Lead channel must
be activated. Pull Gain switch boosts overall system gain. Pull to activate.
POST GAIN (8)
Controls the overall volume level of the Lead channel. The final level adjustment should be made after the
desired sound has been achieved.
BOTTOM (9)
An active tone control (shelving type ±15 dB) that varies the low frequency boost or cut.
NOTE: This control is not functional on the Normal channel.
BODY (10)
An active tone control (peak/notch, ±15 dB) that varies the mid frequency boost or cut.
NOTE: This control is not functional on the Normal channel.
EDGE (11)
An active tone control (shelving type, ±15 dB) that varies the high frequency boost or cut.
NOTE: This control is not functional on the Normal channel.
REVERB (12)
Controls the overall reverb level.