Need help?Do you have a question about the Peavey Butcher and is the answer not in the manual?
General| Preamp Tubes | 4 x 12AX7 |
|---|---|
| Footswitch | Optional (for channel switching) |
| Power Output | 100 Watts |
| Dimensions | 24.5" x 10.5" x 10" |
| Controls | Master Volume |
| EQ | Passive Bass, Middle, Treble |
| Effects Loop | Yes |
| Outputs | Speaker Outputs |
Detailed overview of the amplifier's channels, controls, tubes, and key features.
Applies mains power to the unit. Power status lamp illuminates when ON.
Places the amp in STANDBY mode. Tubes stay hot, but amp is not operational.
Power amp tone control that adjusts high-frequency damping in the power amp.
Sets a second Master Volume at a different level than Master Volume 1.
Sets the overall volume level of the amp. Clockwise rotation increases level.
Toggles between Master Volume 1 and Master Volume 2 via footswitch or MIDI.
Sets the volume of the Clean channel.
Controls the low-frequency response of the Clean channel.
Controls the mid-frequency response of the Clean channel.
Controls the high-frequency response of the Clean channel.
Activates a preamp boost in the Clean channel for pronounced overdrive.
Controls the input volume level of the Clean channel, increasing preamp distortion.
Sets the volume for the Crunch channel.
Controls the low-frequency response of the Crunch channel.
Controls the mid-frequency response of the Crunch channel.
Controls the high-frequency response of the Crunch channel.
Activates a preamp boost in the Crunch channel for more gain.
Controls the input volume level of the Crunch channel, increasing preamp distortion.
12-way selector adjusting low-end attack for playing styles.
Two-position toggle switch for Clean/Crunch channel selection.
1/4" jack for guitar output signal.
Sets the level of signal sent to external effects processors.
1/4" mono jacks for sending to and returning from external effects.
Sets the level of signal returned from external effects processors.
Eight-pin DIN connector for remote footswitch or MIDI control.
Microphone Simulated Direct Interface for direct signal to mixing console.
Three-position switch for selecting speaker cabinet impedance.
Paralleled 1/4" mono jacks for connecting speaker enclosure(s).
Reduces output power from 100W to 50W for different tonal characteristics.
Standard connector for the AC power cord.
Details on the 3-conductor power cord and grounding.
Wiring instructions for UK mains lead.
Location and replacement instructions for the fuse.
Toggles between the Clean channel and the Crunch channel.
Toggles the Effects Loop on or off. Indicator light shows status.
Switches on the preamp boost on the Clean channel.
Connects the included eight-pin cable to the amp's footswitch/MIDI input jack.
Switches on the preamp boost on the Crunch channel.
Toggles between the two Master Volume controls.
Procedure for selecting the MIDI channel for the amplifier.
Details on Continuous Controller messages for amp functions.
Details on Program Change messages for amp functions.
Details what the Peavey warranty covers and does not cover.
Explains how to obtain warranty service and what Peavey will do.
Covers limitations on implied warranties and exclusion of damages.
To Next Page
