Need help?Do you have a question about the Peavey Renown and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Reverb | Yes |
| Effects Loop | Yes |
| Speakers | 2 x 12 inch |
| Inputs | 2 |
| Speaker Configuration | 2x12" |
| EQ | 3-band |
Warning against exposing the appliance to rain or moisture to prevent electrical shock or fire hazards.
Details Peavey's new Renown solid-state amplifier, highlighting new circuitry and performance improvements.
Description of the two input jacks (high and low gain) and their sensitivities for optimal signal input.
Explanation of the GAIN BLOCK™ signal processing front end for total control of gain structure and dynamics.
Details the pre gain control, its logarithmic taper, and the pull switch for high frequency boost.
Explains the SATURATION™ control for achieving tube-like gain compression and harmonic richness.
Describes the post gain control as a master volume, managing power amp sensitivity and overload dynamics.
Details the low frequency EQ control for shaping the amplifier's low-end response, ideal for musical instrument applications.
Explains the vital midrange EQ control, its interaction with other EQ bands, and its effect on tonal color.
Covers the high frequency EQ control and the 'PULL THICK' function for added midrange fullness.
Details the active presence circuit for precise tailoring of extreme highs, allowing mellow or biting tones.
Describes the normal channel pre gain control, its logarithmic taper, and the pull switch for high frequency boost.
Explains the post gain control for the normal channel, similar to master volume, managing preamp overload.
Details the active EQ for the normal channel, including low, Paramid™, and high EQ controls for tonal versatility.
Controls the amount of delayed (reverb) signal blended back into the main output signal.
Indicates when the electrical supply is providing power to the amplifier.
Three-position switch to manage internal grounding capacitor for noise reduction or proper grounding.
Simple two-position switch for turning the amplifier on and off.
Standard DIN type socket for connecting the supplied remote footswitch for channel selection.
Allows 'in line' patching of accessories and connection to external devices.
Connects internal and external speakers, supporting 2 and 4 ohm loads for optimal power output.
Three-wire line cord with grounding facilities for user safety and noise reduction.
DANGER: Warns about potential permanent hearing loss from exposure to extremely high noise levels.
CAUTION: Advises against extended operation at absolute maximum power levels to prevent speaker damage.
To Next Page