Need help?Do you have a question about the Peavey DTH SM and is the answer not in the manual?
General| Frequency Response | 54 Hz to 18 kHz |
|---|---|
| Impedance | 8 Ohms |
| Sensitivity | 98 dB |
| LF Driver Size | 15 inches |
| Dimensions | 17.5 inches |
| Driver | 15-inch woofer |
Specifies the speaker's frequency range from 68 Hz to 16 kHz on-axis in an anechoic environment.
Indicates the -3 dB point for low-frequency response, set at 68 Hz.
Defines the -10 dB point for usable low-frequency output, at 50 Hz.
Details continuous, program, and peak power ratings for full-range and bi-amp modes.
States the SPL at 1 meter in an anechoic environment for 2.8V input (1 watt).
Provides the maximum SPL achievable by the loudspeaker system.
Lists the specific drivers used: 1508-8 DT Black Widow woofer and 44XT compression driver.
Specifies the tuning frequency of the speaker enclosure, set at 57 Hz.
Indicates the frequency at which the crossover network divides the audio signal.
Reports the time delay for the low-frequency drivers, specified as 0.35 mS.
States the nominal and minimum impedance of the loudspeaker system.
Details the input connectors used, specifying two Neutrik Speakon connectors.
Describes the construction materials and external finish of the loudspeaker enclosure.
Provides the height, width, and depth of the loudspeaker in both inches and centimeters.
States the weight of the loudspeaker system in pounds and kilograms.
Highlights key operational features like switchable modes and specific driver types.
Illustrates the wiring configuration for the 4-pin Speakon connectors.
Details the pin-out and cross-reference for 8-pin Speakon connectors.
To Next Page
