Peavey KB-400 - Fuse; Power Switch; Speaker Outputs

HEAR PANEL_
FUSE (11
The fuse is located within the cap of the fuseholder. II is necessary that thelise be replaced with the prooer type and value fuse if It should tail
in order to avoid damage to the eoulpment and to prevent voiding the warranty. If your unit repeatedly blows fuses. It should be taken to a
qualified service center for repair.
POWER SWITCH 121
On domestic units, the power switch Is of the three-position type with the center position being “OFF." This switch has two “ON ’ positions,
one of which is used to ground the amplMler properly Oneofthe'ON’'positions will yield the lowest amount of residual hum or “popping" and this
is the position that should be used.
On export models, we utilize a simple on ^otf switch that does not have multiple “ON” positions since the groundir^g (earthing) conditions In
most countries are made positively through standard tamper-proof plug-ln syslems,
LINE CORD [3)
For your safety, we have incorporated a three-wire line (malns^ cable with proper grounding facilities. It is not advisable to remove the
ground pin under any circumstances If it is necessary to use the amp in a two-pin plug system without proper grounding facilities, suitable
grounding adaptors should be used. Much less noise and greatly reduced shock hazard exist when the unit is operated with the proper grounded
receptacles.
SPEAKER OUTPUTS |d)
The speaker output jacks are of the standard Vi" type Botn the output jacks are wired In pareliel and either or boih may be used when
connecting your speaker system. The 400RH module is optimized for a minmium total load of 4 ohms. Load Impedances lower than 4 ohms will
overload the power amplifier and cause premature activation of the power amp’s shortcircuit protection system and/orihermai lauIt protection
circuitry. Because of the unique design of the compressor, the circuit will still minimize clipping regardless of load values.
LINE (MAINS! CORD RETAINER (bj
We have provided two large molded line cord retainers ontiierear panel to allow storage of the malnscablefor travel. In operation, the cable
should be completely unwrapped to allow maximum heal dissipation from the rear panel/heatsmk.