Peavey MediaMatrix MM-8802

Panel Features
Page 25Peavey Electronics Corporation
Rear Panel Features
Shown without the Euro connectors attached
1 2 3 4 5 7 8 96 10
MAINS POWER RECEPTACLE IEC power receptacle for connecting factory supplied AC
cable. Only the supplied cable should be used.
MAINS POWER SWITCH Two-position rocker switch toggles mains AC power on or off.
When this switch is in the up position, power is on.
FAULT CONTACT Three-position, removable Euro connector for interfacing external alarm
indicators. The connector provides N.O. and N.C dry contacts. The Fault condition is a
duplicate of the front panel Fault LED.
LEGACY DIGITAL INTERFACE CONNECTOR One 9-pin DB-9 female connector for
interfacing the legacy MM
™
DSP DPU card. Requires the Peavey legacy cable for proper inter-
face.
DIGITAL INTERFACE CONNECTORS Two RJ-45 connectors for connecting the TX
(transmit) and RX (receive) CAT cables to MM DSP-RJ or X-Frame
™
88 digital audio proces-
sor products.
RX LED This LED will illuminate when audio data is successfully received by the transmit-
ting DPU product.
CONTROL VOLTAGE (CV) INPUTS Eight 2-wire, 0-10 V DC control voltage ports for
connecting external analog controls. Positive voltage is supplied across all even numbered
pins, referenced to ground. The control input is on the odd numbered pins.
LOGIC OUTPUTS Eight 2-wire TTL logic output ports. Positive voltage on odd numbered
pins indicates a logic high state. The logic voltage is referenced to ground, wired across the
even numbered pins.
AUDIO INPUT CONNECTORS Eight balanced mic (MM-Mic 4) or line (MM-Line 4) level
analog audio inputs on removable Euro connectors. Inputs are configurable, either mic or line,
in groups of four.
AUDIO OUTPUT CONNECTORS Eight balanced line-level analog audio outputs on
removable Euro connectors.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.