Peavey ReValver MK III - Stomp Boxes;Pedals

Stompboxes/pedals
A module from this category is usually placed before an amp module. They are designed to shape
the sound before it is colored by the amp.
Module name = OverDriver
Descripon = This stomp box is wired somewhat like a Guitar amp, in that it uses 3 stages of diode
distoron. The “Turbo” acts like a “Master,” adding some extra gain before the last stage. This
stomp box could be used to drive a speaker by itself.
Module name = Chorus CS-1
Descripon = This is a versale stereo chorus with adjustable speed and modulaon depth, ste reo
width, feedback, delay and 3 individually adjustable lter bands on the wet signal. A chorus can
be used to enrich the sound.
Module name = ACS-CS1 compressor
Descripon = This compressor is used to even out the volume so that the lower levels do not
com pletely disappear, making the so sounds louder and the loud sounds soer and adding a
certain sustain.
Module name = ACS-LM3 limiter
Descripon = A limiter is a specially tailored dynamics compressor. This parcular limiter com-
presses the sound a factor 50:1 over the given threshold. It will stop sounds or transients over this
threshold, liming the output volume.
22