Peavey ReValver MK III - Page 30

Module name = ACS R2 Stereo Reverb
Descripon = Stereo reverb designed to be placed last in the chain to give ambience or width to
the sound, with adjustable pre-delay and room size. Three lters can be programmed to shape
the character of the wet signal. This reverb is thicker than the Reverb R1; it also has dierent
default lter parame ters.
Module name = Ph2 Phaser
Descripon = Phasing works by mixing the original signal with one that is phase shied. This
phaser features a feed back and width control for stereo eects.
Module name = SCH-1B Noise gate
Descripon = A noise gate is a simple way to get rid of noise in the signal. The tradional way this
eect works is by lowering the volume of the signal when the signal itself becomes very weak.
The SCH-1B is dierent in two ways. First, this noise gate does not operate on a closed-only or
open-only basis, but is variable. Sec ond, SCH-1B does not aect the actual “volume” but connu-
ously changes the lter param eters of an intelligent lter circuit. You may noce that the noise
gate is half-closed when playing soly. Compared to tradional noise gates this has the eect of
being perfectly responsive. The noise gate has four separate bands, and the fourth has an adjust-
able frequency.
29