Peavey ReValver MK III - Page 38

You can save the ImpulseResponse (IR) of a module to a .wav le in 44.1 kHz stereo. The impulse
response is praccally the same view as the frequency analyzer, but this tool allows you to save
the response to disk. This IR can be used in the convoluon speaker module (or any other IR
plug-in by third party manufacturers) and can be very useful capturing a “lter” or a “sound” of
any module in ReValver MK III, or any VST plug-in in the VST module. You can even capture the
sound of a third party speaker simulator from another VST plug-in and run it inside of the speaker
convoluon module!
Allmodulesoersomeedingfeaturesandmayinclude:tubes(andtubecon-
guraon),tonestack(ltercollecon),ltercoloring,recerproperes,trans-
formerproperes,negavefeedback,speakercabinet,microphoneandloud-
speaker.
37