Peavey SANPERA I - PRESET MODE; Storing Presets

®
SANPERA I
™
PRESET MODE
When you rst plug your Sanpera I into the amplier
(using the provided 8 pin MIDI cable) the pedal will
default to PRESET mode. In this mode buttons 1-4
correspond with the four PRESET buttons on your
VYPYR
®
. Each button allows you to select one of the
four presets within the bank (group of four presets)
selected on the amplier. Remember, each VYPYR has
12 onboard presets, which are stored in three BANKS of
four labeled A, B and C. To change BANKS using your
Sanpera I, please see BANK SELECT mode.
To store your personal amplier settings and replace one of
the onboard presets, simply press and hold the button that
corresponds with the location you wish to store the preset.
1
3 4
2 5 6
The Sanpera I operates in three modes, PRESET MODE, LOOPER MODE and BANK
SELECT MODE. The functions of buttons 1-4 will vary depending on which mode you are in.