®
SANPERA I
™
LOOPER CONTROLS
To enter LOOP mode, press buttons 3 and 4 simultane-
ously. Upon entering LOOP mode all active LEDs will
change from red to green, indicating you are in LOOP
mode. In the case, the Stompbox and Delay effects are
set to OFF (See Looper controls items 1 and 2), you may
not see any active LEDs upon entering LOOP mode.
3. Rec/Play
To record a loop for playback, simply start playing, and
when you want to START recording the loop press this
button and the amp will begin recording the loop. When
you want to STOP recording, press this button again and
the looper will stop playing and automatically begin to
playback.
4 . Stop/Reset
To stop a loop in process, press this button. To erase the
currently stored loop (recorded by pressing button 4) press
and hold this button for 3 seconds. The LED above this but-
ton will be green if there is a loop currently being stored.
TIP: You can change amp presets after
you have recorded your loop, allowing
you to play a totally different sound on
top of the loop!
To Next Page
Loading...