Peavey TKO 115 User Manual

NOTE: The preamp output level is approximately 1 volt RMS and is of relatively low impedance (600 ohms).
Any effects device used in this effects loop must be capable of receiving 1 volt input and providing 1 volt
output in order to properly drive the power amp. The Power Amp Input has an internal switch which discon¬
nects the internal preamp.
HEADPHONE JACK (12)
This stereo jack allows signal to flow to both sides of any stereo headset.
POWER LED (13)
Illuminates when AC power is being supplied to the amp.
POWER SWITCH (14)
Depress to “On” position to turn on.
Allow storage of mains cable for travel.
GROUND SWITCH (16)
Three position rocker-type switch which, in most applications, should be operated in its center or zero posi¬
tion. There may be some situations when audible hum and/or noise will come from the loudspeaker. If this
situation arises, position the ground switch to either positive or negative ( + or -) or until the noise is minimized.
NOTE: Should the noise problem continue, consult your Authorized Peavey Dealer, the Peavey Factory, or
a qualified service technician. THE GROUND SWITCH IS NOT FUNCTIONAL ON 220/240 VOLT
MODELS.
LINE CORD (120V PRODUCTS ONLY) (17)
For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities. It is not
advisable to remove the ground pin under any circumstances. If it is necevssary to use the equipment without
proper grounding facilities, suitable grounding adaptors should be used. Less noise and greatly reduced shock
hazard exists when the unit is operated with the proper grounded receptacles.
TONE SETTINGS
ROCK
Tone setting* given are general and Mill vary according to type of
guitar, type and gauge* of strings, type of pickup and even type of
pick. Personal taste, playing style, and type of music greatly
contribute to desired tonality.

Peavey TKO 115 Specifications

General

Brand	Peavey
Model	TKO 115
Category	Musical Instrument Amplifier
Language	English