Peavey Tour TNT 115

14
Tour
™
Series Specications
Mains Voltage:
7"$)['"-7
7"$)['"-7
7"$)['"-7
Power Consumption:
600 W
Power Amplifier
Protection:
DDT™ speaker protection with defeat
switch
Short Circuit protection
Thermal protection circuit
Cooling fan failure protection circuit
Current limit protection circuit
DC output protection circuit
Minimum Load:
4 Ω
Input Sensitivity:
600 mVRMS
Output Jacks:
5XP4QFBLPO¥DPNCJOBUJPO
jacks in parallel
Power Output:
X73.4Ȱ
 X73.4Ȱ
Noise:
> 100 dB below full power @ 8 Ω
typically -105 dB
Preamplifier Specifications
Settings (unless otherwise stated):
Pre gain: 4 (12 o'clock)
Bright: Out
Mute: out
Contour: 0 (fully counterclockwise)
Low: 0
High: 0
Low Cut: Out
Graphic EQ: All sliders set to center
EQ Bypass: Out
Post Gain: 10 (fully clockwise)
Octaver: MIN
(fully counterclockwise)
Octaver Defeat: Out
DDT™: Active
Input Sensitivity (High Gain):
Nominal Input: 616 mVRMS
Minimum Input: 34.1 mVRMS
Maximum Input: 2.3 VRMS
(maximum signal at input before clipping)
Input Sensitivity (Low Gain):
Nominal Input: 1.0 VRMS
Minimum Input: 59.3 m VRMS
Maximum Input: 7.2 VRMS
(maximum signal at input before clipping)
Tuner Send:
Buffered from input jack with no
equalization
D.I. XLR Output:
Buffered from input jack with no
equalization
Failsafe D.I. Backup:
48 v phantom power
Weight:
75 lbs.
Dimensions (h x w x d):
YY
Tour Series TNT Combo
Features and specifications subject to change without notice.
All specifications tested with mains voltage maintained at nominal level.