Peavey TourTM Series - Power Output; Power Consumption; Output Jacks

13
Tour
™
Series Specications
Mains Voltage:
120 VAC 60 Hz - 10 amp fuse
230 VAC 50/60 Hz - 6 amp fuse
100 VAC 50/60 Hz - 12 amp fuse
Power Consumption:
1000 W
Power Amplifier
Protection:
DDT™ speaker protection
with defeat switch
Short Circuit protection
Thermal protection circuit
Cooling fan failure protection circuit
Current limit protection circuit
DC output protection circuit
Minimum Load:
4 Ω
Input Sensitivity:
750 mVRMS
Output Jacks:
Two 1/4" Speakon® combination
jacks in parallel
Power Output:
500 w, 63.2 VRMS/8 Ω
700 w, 52.9 VRMS/4 Ω
Noise:
> 100 dB below full power @ 8 Ω
typically -105 dB
Preamplifier Specifications
Settings (unless otherwise stated):
Pre gain: 4 (12 o'clock)
Bright: Out
Mute: out
Contour: 0 (fully counterclockwise)
Low: 0
High: 0
Low Cut: Out
Graphic EQ: All sliders set to center
EQ Bypass: Out
Post Gain: 10 (fully clockwise)
Octaver: MIN
(fully counterclockwise)
Octaver Defeat: Out
DDT™: Active
Input Sensitivity (High Gain):
Nominal Input: 740 mVRMS
Minimum Input: 41.6 mVRMS
(pre gain fully counterclockwise)
Maximum Input: 2.3 VRMS
(maximum signal at input before clipping)
Input Sensitivity (Low Gain):
Nominal Input: 1.3 VRMS
Minimum Input: 72 m VRMS
(pre gain fully counterclockwise)
Maximum Input: 7.2 VRMS
(maximum signal at input before clipping)
Tuner Send:
Buffered from input jack with no
equalization
D.I. XLR Output:
Buffered from input jack with no
equalization
Failsafe D.I. Backup:
48 v phantom power
Weight:
24.0 lb.
Dimensions (h x w x d):
3.875 x 19.00 x 12.50
Tour 700
Features and specifications subject to change without notice.
All specifications tested with mains voltage maintained at nominal level.