5
Description
The Peavey
®
TriFlex
™
is a powered‚ three-way piece speaker system designed to provide the highest levels of
performance in a compact package. The subwoofer unit is loaded with the new‚ high power handling 15" Low Rider
®
Black Widow
®
bass woofer. The TriFlex subwoofer is constructed of premium plywood‚ covered with a tough‚ road-
worthy black carpet. A 16-gauge, perforated metal grille with powder-coated finish covers the front of the system to
protect the speakers. The TriFlex includes two tripod pole stands for mounting the speakers.
Flexibility is designed into the TriFlex. Balanced inputs for each channel are provided and include one combo female
XLR and 1/4" TRS phone jack plus one male XLR thru, all connected in parallel. The power amplifiers are low-
distortion units that supply 1500 Watts of peak dynamic power to the bridged subwoofer, and up to 750 Watts peak
dynamic power to the left and right satellite speakers. The amplifiers feature Peavey’s patented DDT
™
compression
that virtually eliminates audible power amplifier clipping.
For ease of transport, inset metal handles on each side of the sub are provided. For pack-up and transport, removable
locking casters are located on the rear of the sub. This allows the unit to be rotated onto its back and moved with
ease. In this position, the satellites are designed to rest face-to-face on the sub's grille. The entire unit is slipcovered,
with a protective flap for the amplifier, which becomes the bottom of the unit when rolled. The speaker cables are
placed in the cover pockets and the speaker stands in their own pouches. This makes for a compact and complete
package for easy transport.
Fuse (1)
The TriFlex AC is protected from overload and
fault conditions with an ABC-type fast-blow 15 Amp
fuse. The fuse is located within the cap of the fuse
holder. If the fuse fails, THE FUSE MUST BE
REPLACED WITH THE SAME TYPE AND VALUE
IN ORDER TO A
VOID DAMAGE TO THE
EQUIPMENT AND TO PREVENT VOIDING THE
WARRANTY. If the amplifier repeatedly blows the fuse, it should be taken to a qualified service center for repair.
IEC Power Cord Connection (2)
This receptacle is intended to accept an IEC terminated line cord (included) that provides AC power to the unit. It
is very important that you ensure the TriFlex is supplied with the proper AC power line voltage. You can find the
proper voltage for your TriFlex printed next to the IEC line (power) cord on the rear panel of the unit.
If a North American AC power receptacle is of the two-wire type (i.e., does not include a third wire ground pin
hole), never circumvent this situation by breaking off the ground pin of the A
C power cord. The ground pin is
provided for your safety. Suitable grounding adapters are available at your local hardware store. This allows proper
third-wire grounding to the AC power outlet cover screw. To prevent the risk of shock or fire, always make sure
that all other associated audio equipment is also properly grounded, preferably to the same AC power outlet
breaker circuit.
Power Switch (3)
This rocker switch supplies AC mains power to the TriFlex when in the ON position.
Power LED (4)
This LED illuminates when the Power Switch is in the ON position.
R
E
A
R
P
A
N
E
L
ON OFF
POWER
15A
60 Hz
120 VAC
600 WATTS
F
F
U
U
S
S
E
E
13
4
2
To Next Page
Loading...
